5/8″ x 1-1/2″ Steel Flat Bar CF-1018

5/8" x 1-1/2" Steel Flat Bar CF-1018

5/8″ x 1-1/2″ Steel Flat Bar CF-1018

Price range: $13.03 through $68.18

Part#: SFLCF58112 Category
DESCRIPTION

5/8″ x 1-1/2″ CF-1018 Steel Flat Bar

Cold rolled steel flat bar is a low-carbon steel product that’s processed to have a smooth surface and precise dimensions. It’s often used for bending, machining, and other fabrication processes.

Characteristics

  • Strength: Cold rolled steel flat bar has higher tensile and yield strength than hot rolled steel
  • Surface: Cold rolled steel flat bar has a smooth, dark grey oiled surface
  • Dimensions: Cold rolled steel flat bar has precise dimensions and close tolerances
  • Process: Cold rolled steel flat bar is made by heating hot rolled steel, then cooling it at room temperature and rolling it again

Uses

  • Machining: Cold rolled steel flat bar is often used for machining, jigs, and templates
  • Bending: Cold-rolled steel flat bar is better suited for bending applications than hot-rolled steel
  • Fabrication: Cold rolled steel flat bar is used in general fabrication, shafting, axles, dowels, and spindles

* Prices are subject to change without notice due to fluctuations in the metals market. | All “Value Length” and “Value Pack” item measurements are subject to standard mill tolerances. | Products may be manufactured several thousandths of an inch over or under the stated dimensions and still be within acceptable mill tolerances. All bar, tube, structural, pipe, sheet, plate, and similar products sold on our website are custom cut to the lengths and sizes selected by the customer at the time of purchase. These are not stocked as pre-cut items. Because each order is cut specifically to customer specifications, all cut materials are considered custom products and are not eligible for cancellation, return, or exchange once production has begun. Our standard cutting tolerances are:

  • Length: +0.125″ / -0.062″
  • During the cutting process, the saw blade removes approximately 1/16″ (kerf) of material. This is a normal part of the manufacturing process and is already included within the stated cutting tolerances.