1/8″ x 3″ Rectangular Aluminum Flat Bar 6061-T6

1/8" x 3" Rectangular Aluminum Flat Bar 6061-T6

1/8″ x 3″ Rectangular Aluminum Flat Bar 6061-T6

$6.50 – $41.00

Part#: AFL61183 Categories ,
DESCRIPTION

An aluminum flat bar 6061 1/8 x 3

📐 Dimensions:

  • Thickness: 1/8 inch (0.125″)
  • Width: 3 inches (3.00″)

🧪 Material: 6061 Aluminum Alloy

  • One of the most commonly used aluminum grades
  • Known for:
    • High strength-to-weight ratio
    • Excellent corrosion resistance
    • Good weldability and machinability
    • Can be anodized for protection or aesthetics

🔧 Typical Uses:

  • Mounting plates or base plates
  • Brackets or support bars
  • Machine shop or fabrication projects
  • DIY or garage builds (e.g., jigs, fixtures, backing plates)
  • Decorative architectural trim
  • Spacer or shim where a wider contact area is needed

(Value Pack of 3 pcs at 48″ long)*

* Prices subject to change without notice due to the Metals Market fluctuations.
* All ‘value length’ and ‘value pack’ item measurements are subject to a “mill tolerance”. A product may be produced several thousandths of an inch, either over or under the stated thickness, and still be within “mill tolerance”. This does NOT apply to Cut To Size items. Those will be +.125″, -0.00″ tolerances.

metals 4 u logo
Physical Address:

1240 Majesty Dr., Dallas, TX-75247

Mailing Address:

P.O. Box 560626, Dallas, TX-75247

Direct Any Correspondence To:

METALS 4U

1240 Majesty Dr., Dallas, TX-75247

+1 (214) 231-1434

Buy Securely — UPS Ships Direct to You!
credit card
Need Some Help?
WARNING
warning icon

CALIFORNIA PROPOSITION 65

This product can expose you to chemicals which are known to the State of California to cause cancer, birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov

Prices subject to change without notice due to the Metals Market fluctuations. | All ‘value length’ and ‘value pack’ item measurements are subject to a “mill tolerance”. | A product may be produced several thousandths of an inch, either over or under the stated thickness, and still be within “mill tolerance”. This does NOT apply to Cut To Size items. Those will be +.125”, -0.00” tolerances. 

Facebook-f Instagram