1/4″ x 12″ Rectangular Aluminum Flat Bar 6061-T6 Structural

1/4" x 12" Rectangular Aluminum Flat Bar 6061-T6 Structural

1/4″ x 12″ Rectangular Aluminum Flat Bar 6061-T6 Structural

$95.11 – $140.17

Part#: AFL611412in Category
DESCRIPTION

An aluminum flat 1/4 x 12 6061-T6

📏 Dimensions:

  • Thickness: 1/4 inch (0.250″)
  • Width: 12 inches

🧪 Material – 6061-T6 Aluminum:

  • 6061: A widely used aluminum alloy known for its good strength, corrosion resistance, weldability, and machinability
  • T6 Temper: The material has been solution heat-treated and artificially aged, resulting in increased strength and hardness

⚙️ Mechanical Properties (Typical):

  • Tensile Strength: ~45,000 psi
  • Yield Strength: ~40,000 psi
  • Brinell Hardness: ~95
  • Density: 0.0975 lb/in³

🧰 Common Uses:

  • Structural fabrication
  • Mounting plates and base plates
  • Equipment frames
  • Tooling surfaces
  • Marine and aerospace brackets

* Prices subject to change without notice due to the Metals Market fluctuations.
* All ‘value length’ and ‘value pack’ item measurements are subject to a “mill tolerance”. A product may be produced several thousandths of an inch, either over or under the stated thickness, and still be within “mill tolerance”. This does NOT apply to Cut To Size items. Those will be +.125″, -0.00″ tolerances.

metals 4 u logo
Physical Address:

1240 Majesty Dr., Dallas, TX-75247

Mailing Address:

P.O. Box 560626, Dallas, TX-75247

Direct Any Correspondence To:

METALS 4U

1240 Majesty Dr., Dallas, TX-75247

+1 (214) 231-1434

Buy Securely — UPS Ships Direct to You!
credit card
Need Some Help?
WARNING
warning icon

CALIFORNIA PROPOSITION 65

This product can expose you to chemicals which are known to the State of California to cause cancer, birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov

Prices subject to change without notice due to the Metals Market fluctuations. | All ‘value length’ and ‘value pack’ item measurements are subject to a “mill tolerance”. | A product may be produced several thousandths of an inch, either over or under the stated thickness, and still be within “mill tolerance”. This does NOT apply to Cut To Size items. Those will be +.125”, -0.00” tolerances. 

Facebook-f Instagram